Canon imageCLASS MF5960dn E004 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageCLASS MF5960dn E004 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageCLASS MF5960dn E004 0000 Error Code
E004 0000
Description :
Error in fixing power supply drive circuit
Causes :
Failed to detect the zero cross signal for the specified period of time or more.
Solutions :
1. Check the connection of connector between the Fixing Assembly and the Engine Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the Engine Controller PCB.
HP RM1-6405-000cn Fuser (Fixing) Unit – 120 Volt (Genuine) – $129.95
Canon imageCLASS MF5960dn Fuser Removal and Replacement RM1-6405-000, FM4-3436-000
Remember that, not every error is absolutely identical. What treats the problem one time may not remedy it the next time. While the help and advice in this written piece hails from the service manual and usually should get your piece of equipment ready to go, now and again other factors can be in play.
If you are reading this piece of content and have exposure to this error and wish to share you should leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have knowledge about the issue then I will reply.
