Canon imageCLASS D1370 E736 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageCLASS D1370 E736 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageCLASS D1370 E736 0000 Error Code
E736 0000
Description :
Communication error with CCU/modem
Causes :
Communication error with CCU/modem.
NCU PCB type error.
Solutions :
1. Install the set of the controller firmware.
2. Replace the NCU PCB.
3. Replace the Main Controller PCB.
Realize, not every error is totally alike. What remedies the difficulty one time might not eliminate it the next time. While the ideas in this document is obtained from the service manual and most likely should get your device functioning, in some cases additional factors can be in play.
If you’re looking over this write-up and have knowledge about this error and would wish to make a contribution you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have experience with the problem then I will answer back.
