Canon imageCLASS D1370 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageCLASS D1370 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageCLASS D1370 E003 0000 Error Code
E003 0000
Description :
Abnormal low temperature of Fixing Assembly
Causes :
It was detected that the temperature of the Fixing Assembly was abnormally low.
Solutions :
1. Check the connector between the Fixing Assembly and the DC Controller PCB.
2. Replace the Fixing Assembly.
3. Replace the DC Controller PCB.
HP RM1-6405-000cn Fuser (Fixing) Unit – 120 Volt (Genuine) – $129.95
Canon imageCLASS D1370 Fuser Removal and Replacement RM1-6405-000, FM4-3436-000
Please remember, not every error is absolutely the same. What corrects the complication one time might not take care of it the next occasion. While the content in this writing originates from the service manual and normally should get your product operating, on occasion other causes may be in play.
If you’re looking over this document and have knowledge of this malfunction and would wish to contribute please leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have exposure to the trouble then I will respond.
