Kyocera KM-3040 C6000 Error Code Servicing Tips
I maintain a few of these in this area and I do not believe I’ve actually encountered the Kyocera KM-2540 C6000 Error code on one of these particular devices. Although, these machines are getting more aged and if you have had the exact same fusing assembly in there ever since you’ve had it, you may be seeing an example of these errors. Below you will see the service manual information for this error and additionally a hyperlink to shop for a new fuser and also at bottom end of the article content, a web site link for the fuser replacement assistance
Be aware : fuser unit Connected Error Codes will cause the product to fail to work before the code is reset in Maintenance Mode. Below is the instructions on simple methods to reset the code within the maintenance menu.
Kyocera KM-3040 Fuser Error Reset Procedure – 302K593060
Service Guide Recommendation for the Kyocera KM-3040 C6000 Error Code
fusing unit heater break fuser unit thermistor 1 detected a lesser amount than 40°C/104°F for 10 s going through warm-up and ready in.
1. Flawed fusing unit heater M or S.
Swap out the fusing assembly heater M or S.
2. Set up defectiveness on fuser thermistor 1.
Inspect the mounting state of the fuser thermistor 1. If any problem is spotted, fix it.
3. Fixing thermostat stimulated.
Check out continuity. If none, change the fixing thermostat.
4. Flawed PWB.
Change out the power source PWB or engine PWB and verify for proper operation.
5. Destroyed fixing heater M or S wire.
Pay attention to continuity. If none, exchange the heater lamp.
Seriously, Ordering these parts one-by-one is often difficult to get or otherwise worth replacing. If your getting worries considering the fuser unit and you decide it’s time for you to start repairing components it’s likely just time to remove and replace the complete fusing unit provided the expense. Just below you will notice a url to get in a replacement fuser unit and a website link to the illustrated fusing unit replacement guidance.
Kyocera KM-3040 Fuser Replacement Procedure
Kyocera code c6000
Kyocera code c6020 Kyocera code c6050 code Kyocera KM1620 Kyocera KM1635 Kyocera KM1650 Kyocera KM2020 Kyocera KM2030 Kyocera KM2035 Kyocera KM2050 Kyocera KM2530 Kyocera KM2540 Kyocera...