Oct 182016
 
 

CopyStar CS-300i C6150 Error Code Repair Advice

The CopyStar CS-300i C6150 Error Code is related to a low temperature reading in the fusing unit. Lots of things can cause this issue. So in this article you will find some repair tips for this error along with links to purchase a new fuser and at the bottom of the article you will find a link to the illustrated fuser replacement instructions.

CopyStar CS-300i C6150 Error Code


Copystar CS300i Fuser Unit – 120 Volt (Genuine) – $169.95

from: Precision Roller

Note : Fuser Related Error Codes can cause the machine not to work until the code is reset in Maintenance Mode. Below is a link to the instructions on how to reset the code through the maintenance menu.

CopyStar CS-300i Fuser Error Reset Procedure – 302K593060

Service Manual Advice for the CopyStar CS-300i C6150 Error Code 

Abnormally low fuser thermistor edge temperature
Fuser thermistor 1 is detected 100°C/212°F less than 1 s continuously during copying.

1. Defective fuser heater M or S.
Replace the fuser heater M or S.

2. Installation defectiveness on fuser thermistor 1.
Check the mounting state of the fuser thermistor 1. If any problem is found, repair it.

3. Defective PWB.
Replace the power source PWB or engine PWB and check for correct operation.

These fusers are relatively cheap. Like many parts on the Kyocera machines, lots of times its more cost effective to just replace the whole part or maintenance kit. Therefore, if you are having problems with the fuser, I would just recommend saving some time and money and purchase a whole replacement fuser. Below, you will find a link to the replacement instructions along with a link to order in your replacement fuser.

CopyStar CS-300i Fuser Replacement Procedure


Copystar CS300i Fuser Unit – 120 Volt (Genuine) – $169.95

Genuine 302K593060 Fuser Unit – 120 Volt for Copystar CS300i; Fuser Assembly / Unit – Genuine Kyocera Fuser Assembly; Copystar 302K593060 / 302H093030 / 2H093030