Canon imageRUNNER 2545I E805 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E805 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E805 0001 Error Code
E805 0001
Description :
Causes :
1.When lock signal failed to be detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is driven.
2.When lock signal failed to be detected for 5 sec while the Finisher Fan 1 (M8) is driven.
3.When lock signal failed to be detected for 5 sec while the Finisher Fan 2 (M9) is driven.
* The same condition is detected after the error retry is performed.
Solutions :
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the Finisher Fan 1 (M8).
4.Replace the Finisher Fan 2 (M9).
5.Replace the DC Controller PCB (PCB4).
Note, not every error is completely alike. What remedies the trouble one time might not exactly take care of it the next occasion. While the info in this posting is inspired by the service manual and oftentimes should get your machine working, on occasion other reasons may be in play.
If you are reading this short article and have information about this error and would like to make a contribution you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have experience with the trouble then I will answer.
