Kyocera KM-2540 C6050 Error Code Repair Advice
The Kyocera KM-2540 C6050 Error Code is related to a low temperature reading in the fusing unit. Lots of things can cause this issue. So in this article you will find some repair tips for this error along with links to purchase a new fuser and at the bottom of the article you will find a link to the illustrated fuser replacement instructions.
Note : Fuser Related Error Codes can cause the machine not to work until the code is reset in Maintenance Mode. Below is a link to the instructions on how to reset the code through the maintenance menu.
Kyocera KM-2540 Fuser Error Reset Procedure – 302K593060
Service Manual Advice for the Kyocera KM-2540 C6050 Error CodeÂ
Abnormally low fuser thermistor center temperature
Fuser thermistor 2 is detected 100°C/212°F less than 1 s continuously during copying.
1. Defective fuser heater M or S.
Replace the fuser heater M or S.
2. Installation defectiveness on fuser thermistor 2.
Check the mounting state of the fuser thermistor 2. If any problem is found, repair it.
3. Defective PWB.
Replace the power source PWB or engine PWB and check for correct operation.
These fusers are relatively cheap. Like many parts on the Kyocera machines, lots of times its more cost effective to just replace the whole part or maintenance kit. Therefore, if you are having problems with the fuser, I would just recommend saving some time and money and purchase a whole replacement fuser. Below, you will find a link to the replacement instructions along with a link to order in your replacement fuser.
Kyocera KM-2540 Fuser Replacement Procedure
Kyocera code c6000
Kyocera code c6020 Kyocera code c6050 code Kyocera KM1620 Kyocera KM1635 Kyocera KM1650 Kyocera KM2020 Kyocera KM2030 Kyocera KM2035 Kyocera KM2050 Kyocera KM2530 Kyocera KM2540 Kyocera...