Lexmark MX510 40X8736 ADF Pick Up Roller Replacement Procedure
Below you will find the Lexmark MX510 40X8736 ADF Pick Up Roller Replacement Procedure. This procedure is not as easy as it is on some models. However, I believe with a little patients, this can be a job done by just about anybody.
Cause for Lexmark Lexmark MX510 ADF Pick Up Roller Replacement
At around 150,000 pages of the estimated 200,000 pages life cycle of the separation roller you will start having problems with it. They develop flat spots and other deformities that will cause poor feeding and mispick errors. You might get away with just replacing the separation roller but I like to replace both sets of rollers at the same time.
Note : Just remember to order in the separation roller assembly. These parts really need to be replaced at the same time.
Lexmark MX510 40X8736 ADF Pick Up Roller Replacement Instructions
OK, the service manual doesn’t really tackle this procedure.
1. There is two clips on either side of the pick up assembly circled in red. Unclip them and pull them down about 90 decrees and the assembly should just pop out.
2. The replacement assembly goes in the same way.
The only thing I’ve had issues with is the paper guides marked in green in the picture. They need to lay flat in the assembly with a little play. The clips that lock in place have inner clips to hold it to the metal shaft. These inner clips cause a little problem with the guides during install. I’ve found it a little easier to get the pick up assembly in and then mess around with the guides to get them in the right position. Again, they should be flat like the picture shows but they also should fit freely on the shaft to allow for movement.
ADF separator roll removal
1 Open the ADF top cover.
2 Squeeze the latches to release the separator roll.
3 Pull away the separator roll and remove.
