Canon imageRUNNER 2545I E805 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E805 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E805 0003 Error Code
E805 0003
Description :
Causes :
When lock signal failed to be detected for 5 sec while the Exhaust Fan (Front) (FAN4) is driven
* The same condition is detected after the error retry is performed.
Solutions :
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Front) (FAN4).
3.Replace the DC Controller PCB (PCB4).
Note, not every error is completely alike. What corrects the malfunction one time may possibly not resolve it the next occasion. While the help and advice in this writing is inspired by the service manual and generally should get your piece of equipment functioning, from time to time additional factors may be in play.
If you are reading this short article and have exposure to this malfunction and would wish to make a contribution make sure you leave a comment down below. Or, if you have read this article and have further questions then ask. If I have knowledge about the issue then I will reply.
