Canon imageRUNNER 2545I E532 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E532 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E532 0001 Error Code
E532 0001
Description :
Causes :
The stapler does not leave the stapler move home position when the STP Move Motor (M1) has been driven for 0.25 sec.
Solutions :
1.Replace the Stapler Move HP Sensor (S10).
2.Check the wiring between the Finisher Controller PCB and the STP Move Motor.
3.Check the stapler shift base.
4.Replace the STP Move Motor (M1).
5.Replace the Finisher Controller PCB (PCB1).
Note, not every error is exactly the same. What corrects the condition one time may possibly not fix it the next occasion. While the guidance in this short article is inspired by the service manual and most likely should get your piece of equipment operating, from time to time other elements could possibly be in play.
If you’re looking at this article and have expertise in this fault and wish to make a contribution please be sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will reply.
