Canon imageRUNNER 2545I E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E531 8002 Error Code
E531 8002
Description :
Causes :
The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec.
Solutions :
1.Check the wiring between the Finisher Controller PCB and Stapler.
2.Replace the Stapler.
3.Replace the Finisher Controller PCB (PCB1).
Note, not every error is exactly the same. What corrects the situation one time might not take care of it the next occasion. While the data in this short article is taken from the service manual and generally should get your product operational, on occasion additional factors may be in play.
If you’re looking at this article and have expertise in this fault and would wish to make a contribution please leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have exposure to the problem then I will reply.
