Canon imageRUNNER 2545I E280 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E280 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E280 0000 Error Code
E280 0000
Description :
Causes :
Reading error after writing.
Solutions :
1.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 50pin).
2.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 64pin).
3.Disconnect and then connect the flexible cable(CCD unit- Relay PCB (PCB2)).
4.Replace the flexible cable.
5.Replace the Relay PCB (PCB2).
6.Replace the Main Controller PCB (PCB1).
Note, not every error is precisely the same. What corrects the malfunction one occasion might not get rid of it the next time. While the ideas in this writing derives from the service manual and in most cases ought to get your device up and running, from time to time additional circumstances could possibly be in play.
If you’re looking at this article and have exposure to this error message and would wish to contribute please be sure to leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have exposure to the problem then I will reply.
