Canon imageRUNNER 2545I E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E261 0000 Error Code
E261 0000
Description :
Causes :
Zero Cross failed to be detected for 500ms or more while the relay was ON.
* The same condition is detected after the error retry is performed.
Solutions :
1.Check the Connectors.
2.Replace the DC Controller PCB (PCB4).
Note, not every error is precisely the same. What fixes the problem one occasion might not solve it the next time. While the guidance in this short article is obtained from the service manual and most likely should get your machine operational, at times other things can be in play.
If you’re looking at this article and have exposure to this fault and desire to contribute be sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the difficulty then I will answer back.
