Canon imageRUNNER 2545I E002 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545I E002 0000 Error Code
E002 0000
Description :
Causes :
1.The reading of the main thermistor is less than 115 deg C continuously for 400 msec 1.3 sec after it has indicated 100 deg C.
2.The reading of the main thermistor is less than 150 deg C continuously for 400 msec 1.3 sec after it has indicated 140 deg C.
Solutions :
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Please remember, not every error is absolutely alike. What fixes the condition one occasion might not fix it the next time. While the data in this page is obtained from the service manual and generally ought to get your piece of equipment up and running, in some cases other variables could possibly be in play.
If you’re looking at this blog post and have information about this error message and want to make a contribution be sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the difficulty then I will answer.
