Canon imageRUNNER 2545 E805 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E805 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545 E805 0000 Error Code
E805 0000
Description :
Causes :
When lock signal is detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is stopped.|* The same condition is detected after the error retry is performed.
Solutions :
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the DC Controller PCB (PCB4).
Please remember, not every error is absolutely the same. What fixes the issue one occasion might not solve it the next time. While the tips in this posting hails from the service manual and in most cases should get your piece of equipment up and running, on occasion additional factors could possibly be in play.
If you’re looking at this document and have experience with this fault and want to share please be sure to leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the trouble then I will respond.
