Canon imageRUNNER 2545 E002 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2545 E002 0000 Error Code
E002 0000
Description :
Causes :
1.The reading of the main thermistor is less than 115 deg C continuously for 400 msec 1.3 sec after it has indicated 100 deg C.
2.The reading of the main thermistor is less than 150 deg C continuously for 400 msec 1.3 sec after it has indicated 140 deg C.
Solutions :
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Realize, not every error is completely identical. What fixes the trouble one occasion may not get rid of it the next time. While the content in this write-up hails from the service manual and most often should get your piece of equipment operational, from time to time other things might be in play.
If you’re looking at this post and have information about this error and would like to share make sure you leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have experience with the problem then I will reply.
