Canon imageRUNNER 2535I E804 0001 Error Code

 

Canon imageRUNNER 2535I E804 0001 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 2535I E804 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 2535I E804 0001 Error Code

Service Manual Instructions for the Canon imageRUNNER 2535I E804 0001 Error Code

E804 0001
Description :

Causes :
When lock signal failed to be detected for 5 sec while the Power Supply Cooloing Fan (FAN6) is driven.
* The same condition is detected after the error retry is performed.

Solutions :
1.Disconnect and then connect the connector (J205) on the DC Controller PCB (PCB4).
2.Replace the Power Supply Cooloing Fan (FAN6).
3.Replace the DC Controller PCB (PCB4).




Realize, not every error is entirely alike. What remedies the issue one occasion may not remedy it the next occasion. While the material in this post is obtained from the service manual and normally should get your equipment up and running, on occasion other factors may be in play.

If you’re looking at this post and have knowledge of this error and would like to share please leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the issue then I will answer.

We will be happy to hear your thoughts

Leave a reply

Shopping cart