Canon imageRUNNER 2535I E532 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E532 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535I E532 0001 Error Code
E532 0001
Description :
Causes :
The stapler does not leave the stapler move home position when the STP Move Motor (M1) has been driven for 0.25 sec.
Solutions :
1.Replace the Stapler Move HP Sensor (S10).
2.Check the wiring between the Finisher Controller PCB and the STP Move Motor.
3.Check the stapler shift base.
4.Replace the STP Move Motor (M1).
5.Replace the Finisher Controller PCB (PCB1).
Realize, not every error is precisely the same. What treats the situation one occasion may possibly not remedy it the next occasion. While the data in this blog originates from the service manual and typically should get your unit up and running, from time to time other reasons might be in play.
If you’re looking at this write-up and have expertise in this error message and would wish to make a contribution please leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have experience with the difficulty then I will answer back.
