Canon imageRUNNER 2535I E110 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E110 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535I E110 0003 Error Code
E110 0003
Description :
Causes :
The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed.
* The same condition is detected after the error retry is performed.
Solutions :
1.Check the cable.
2.Replace the Laser Scanner Unit.
3.Replace the DC Controller PCB (PCB4).
Realize, not every error is totally the same. What remedies the issue one time might not take care of it the next time. While the ideas in this blog is inspired by the service manual and normally should get your product up and running, in some cases other causes may be in play.
If you’re looking over this article and have experience with this fault and desire to share you should leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will reply.
