Canon imageRUNNER 2535I E001 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E001 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535I E001 0000 Error Code
E001 0000
Description :
Causes :
The reading of the main thermistor is 250 deg C or more continuously for 200 msec.
Solutions :
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Remember that, not every error is completely alike. What remedies the issue one occasion might not exactly resolve it the next occasion. While the material in this writing comes from the service manual and in most cases should get your device working, at times other causes can be in play.
If you’re looking over this blog post and have experience with this problem and would wish to make a contribution be sure to leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the situation then I will answer back.
