Canon imageRUNNER 2535 E532 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E532 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E532 0002 Error Code
E532 0002
Description :
Causes :
The stapler does not return to the stapler move home position when the STP Move Motor (M1) has been driven for 2.8 sec.
Solutions :
1.Replace the Stapler Move HP Sensor (S10).
2.Check the wiring between the Finisher Controller PCB and the STP Move Motor.
3.Check the stapler shift base.
4.Replace the STP Move Motor (M1).
5.Replace the Finisher Controller PCB (PCB1).
Remember that, not every error is exactly alike. What treats the situation one occasion might not exactly get rid of it the next occasion. While the tips in this writing originates from the service manual and normally should get your equipment up and running, now and again other elements might be in play.
If you’re looking over this document and have information about this fault and would wish to make a contribution please make sure to leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the situation then I will respond.
