Canon imageRUNNER 2535 E532 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E532 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E532 0001 Error Code
E532 0001
Description :
Causes :
The stapler does not leave the stapler move home position when the STP Move Motor (M1) has been driven for 0.25 sec.
Solutions :
1.Replace the Stapler Move HP Sensor (S10).
2.Check the wiring between the Finisher Controller PCB and the STP Move Motor.
3.Check the stapler shift base.
4.Replace the STP Move Motor (M1).
5.Replace the Finisher Controller PCB (PCB1).
Remember that, not every error is exactly identical. What corrects the difficulty one time may possibly not remedy it the next time. While the information in this blog post obtain from the service manual and usually ought to get your product up and running, in some cases other variables can be in play.
If you’re looking over this document and have information about this malfunction and wish to share you should leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have experience with the difficulty then I will reply.
