Canon imageRUNNER 2535 E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E531 8002 Error Code
E531 8002
Description :
Causes :
The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec.
Solutions :
1.Check the wiring between the Finisher Controller PCB and Stapler.
2.Replace the Stapler.
3.Replace the Finisher Controller PCB (PCB1).
Remember that, not every error is exactly identical. What corrects the issue one time might not resolve it the next time. While the details in this piece of content comes from the service manual and typically ought to get your piece of equipment operating, sometimes additional circumstances may be in play.
If you’re looking over this document and have information about this problem and want to make a contribution please make sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the situation then I will reply.
