Canon imageRUNNER 2535 E280 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E280 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E280 0000 Error Code
E280 0000
Description :
Causes :
Reading error after writing.
Solutions :
1.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 50pin).
2.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 64pin).
3.Disconnect and then connect the flexible cable(CCD unit- Relay PCB (PCB2)).
4.Replace the flexible cable.
5.Replace the Relay PCB (PCB2).
6.Replace the Main Controller PCB (PCB1).
Remember that, not every error is precisely alike. What corrects the situation one time may not get rid of it the next time. While the details in this article is obtained from the service manual and most often should get your device ready to go, from time to time other factors can be in play.
If you’re looking over this document and have knowledge of this error message and want to contribute you should leave a comment down below. Or, if you have read this article and have more questions then ask. If I have exposure to the problem then I will answer.
