Canon imageRUNNER 2535 E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E261 0000 Error Code
E261 0000
Description :
Causes :
Zero Cross failed to be detected for 500ms or more while the relay was ON.
* The same condition is detected after the error retry is performed.
Solutions :
1.Check the Connectors.
2.Replace the DC Controller PCB (PCB4).
Remember that, not every error is precisely alike. What fixes the condition one occasion will possibly not resolve it the next time. While the data in this post comes from the service manual and most often ought to get your piece of equipment operating, at times other reasons may be in play.
If you’re looking over this document and have knowledge of this error message and want to contribute you should leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have information about the issue then I will respond.
