Canon imageRUNNER 2535 E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2535 E003 0000 Error Code
E003 0000
Description :
Causes :
The reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
Solutions :
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Remember, not every error is absolutely identical. What corrects the malfunction one time may possibly not take care of it the next occasion. While the ideas in this writing derives from the service manual and in most cases ought to get your product up and running, now and again other elements might be in play.
If you’re looking over this piece of content and have exposure to this error message and would wish to make a contribution be sure to leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have knowledge about the trouble then I will respond.
