Canon imageRUNNER 2018 E003 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2018 E003 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 2018 E003 0001 Error Code
E003 0001
Description :
Abnormally low temperature (detected by sub thermistor)
Causes :
After the temperature detected by the sub thermistor has reached the specified value, it does not reach the specified value during initial rotation.
Solutions :
Check the connector of the fixing film unit.
Replace the fixing film unit.
Replace the DC controller PCB.
Canon FM0-0160-000 Fuser (Fixing) Unit – 120 Volt (Genuine) – $314.95
Canon imageRUNNER 2018 Fuser Removal and Replacement FM0-0160-000, FM3-3651-000
Understand, not every error is totally alike. What remedies the situation one occasion may not resolve it the next time. While the tips in this document is taken from the service manual and normally ought to get your equipment ready to go, in some cases other variables could possibly be in play.
If you are looking over this blog post and have experience with this problem and want to make a contribution you should leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have information about the trouble then I will reply.
