Canon imageRUNNER 1750iF E575 8004 Error Code

 

Canon imageRUNNER 1750iF E575 8004 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1750iF E575 8004 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1750iF E575 8004 Error Code

Service Manual Instructions for the Canon imageRUNNER 1750iF E575 8004 Error Code

E575 8004
Description :
Gripper Motor (M7) clock error

Causes :
When the Gripper Motor (M7) was operated, the Gripper Encoder Sensor (S8) detected rotation of 400 clocks or more.

Solutions :
1. Check the connector connection of the Gripper Encoder Sensor (S8) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper Encoder Sensor (S8) or the Gripper Motor (M7).
3. Replace the Gripper Encoder Sensor (S8).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.


Make sure you remember, not every error is precisely the same. What corrects the situation one occasion might not resolve it the next time. While the info in this posting is obtained from the service manual and most likely ought to get your device ready to go, sometimes additional circumstances may be in play.

If you are reading this post and have experience with this error and want to share make sure you leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have exposure to the difficulty then I will respond.

We will be happy to hear your thoughts

Leave a reply

Shopping cart