Canon imageRUNNER 1750iF E537 8002 Error Code

 

Canon imageRUNNER 1750iF E537 8002 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1750iF E537 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1750iF E537 8002 Error Code

Service Manual Instructions for the Canon imageRUNNER 1750iF E537 8002 Error Code

E537 8002
Description :
Rear Alignment Motor (M5) error

Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to be detected by the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 0.78sec.

Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.


Make sure you remember, not every error is precisely alike. What remedies the malfunction one time will possibly not take care of it the next time. While the guidance in this document is taken from the service manual and generally should get your unit up and running, on occasion other factors may be in play.

If you are reading this piece of content and have knowledge about this problem and would wish to share you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have information about the trouble then I will answer back.

We will be happy to hear your thoughts

Leave a reply

Shopping cart