Canon imageRUNNER 1750iF E537 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E537 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E537 8001 Error Code
E537 8001
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to move from the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Make sure you remember, not every error is precisely alike. What fixes the trouble one occasion will possibly not remedy it the next occasion. While the data in this text is inspired by the service manual and in most cases ought to get your piece of equipment up and running, in some cases other factors might be in play.
If you are reading this piece of content and have knowledge about this problem and would wish to contribute you should leave a comment down below. Or, if you have read this article and have more questions then ask. If I have exposure to the trouble then I will reply.
