Canon imageRUNNER 1750iF E020 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E020 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E020 0000 Error Code
E020 0000
Description :
Detection of toner clog between the Hopper and the Developing Assembly
Causes :
When the Developing Assembly Toner Sensor (TS2) detected “tonerabsent” and the Hopper Toner Sensor (TS1) detected “toner-present”, the Hopper Motor (M6) was rotated 194 times with intermissions of 1 second, but the Developing Assembly Toner Sensor (TS2) could not detect “toner-present”.
If paper is being fed, the error occurs after the paper has been delivered.
Solutions :
1. Check rotation of the Hopper Motor Gear. (If it is rotating, the sensor may not be detecting correctly. In that case, execute Service Mode>CLEAR>ENGIN>TNRINST to supply toner to the Developing Assembly.)
2. Replace the Developing Assembly Toner Sensor (TS2).
3. Replace the Hopper Toner Sensor (TS1).
4. Replace the DC Controller PCB (PCB1).
Make sure you remember, not every error is completely alike. What treats the complication one occasion may possibly not get rid of it the next time. While the data in this article derives from the service manual and normally ought to get your product functioning, in some cases additional circumstances might be in play.
If you are reading this page and have exposure to this malfunction and wish to make a contribution make sure you leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have information about the difficulty then I will answer.
