Canon imageRUNNER 1750iF E010 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750iF E010 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750iF E010 0002 Error Code
E010 0002
Description :
Main Motor (M2) rotation error
Causes :
Detection was performed every 100msec during the drive (after the lock detection) and the lock signal was not detected 5 times in a row (in 500 msec).
Solutions :
1. Check the connector between the Main Motor and the DC Controller PCB (J203).
2. Replace the Main Motor (M2).
3. Replace the DC Controller PCB (PCB1).
Make sure you remember, not every error is absolutely identical. What treats the issue one occasion will possibly not fix it the next occasion. While the information in this short article comes from the service manual and normally should get your piece of equipment working, now and again additional variables could possibly be in play.
If you are reading this page and have experience with this malfunction and desire to share make sure you leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have exposure to the difficulty then I will respond.