Canon imageRUNNER 1750 E822 0004 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E822 0004 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E822 0004 Error Code
E822 0004
Description :
Delivery Cooling Fan (Rear) (FM1) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Rear) (FM1) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Rear) (FM1).
3. Replace the DC Controller PCB (PCB1).
Keep in mind, not every error is simply the same. What fixes the situation one time will possibly not take care of it the next occasion. While the material in this post obtain from the service manual and most likely ought to get your device operational, from time to time other things could possibly be in play.
If you are reading this document and have knowledge about this error message and wish to contribute please be sure to leave a comment down below. Or, if you have read this article and have more questions then ask. If I have knowledge about the trouble then I will answer.
