Canon imageRUNNER 1750 E822 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E822 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E822 0003 Error Code
E822 0003
Description :
Error in rotation of the Delivery Cooling Fan (Center) (FM2)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Center) (FM2) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Center) (FM2).
3. Replace the DC Controller PCB (PCB1).
Keep in mind, not every error is simply the same. What corrects the issue one time might not exactly eliminate it the next occasion. While the information in this page is taken from the service manual and most often should get your unit functioning, sometimes other things could possibly be in play.
If you are reading this document and have information about this malfunction and would wish to make a contribution please make sure to leave a comment below. Or, if you have read this article and have further questions then ask. If I have exposure to the problem then I will reply.
