Canon imageRUNNER 1750 E820 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E820 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E820 0002 Error Code
E820 0002
Description :
Developing Cooling Fan (Rear) (FM8) error
Causes :
A lock signal was detected for 5 seconds while the Developing Cooling Fan (Rear) (FM8) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Rear) (FM8).
3. Replace the DC Controller PCB (PCB1).
Keep in mind, not every error is simply alike. What fixes the condition one occasion may possibly not fix it the next occasion. While the details in this written piece is taken from the service manual and usually should get your machine functioning, sometimes other things might be in play.
If you are reading this document and have exposure to this error and desire to share make sure you leave a comment down below. Or, if you have read this article and have further questions then ask. If I have information about the trouble then I will respond.
