Canon imageRUNNER 1750 E577 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E577 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E577 8001 Error Code
E577 8001
Description :
Paddle Motor (M3) error
Causes :
Although the Paddle Motor (M3) was driven for 175 steps, the Paddle failed to move from the Paddle HP Sensor (S3).
Solutions :
1. Check the connector connection of the Paddle HP Sensor (S3) or the Paddle Motor (M3).
2. Check for open circuit of the Harness of the Paddle HP Sensor (S3) or the Paddle Motor (M3).
3. Replace the Paddle HP Sensor (S3).
4. Replace the Paddle Motor (M3).
5. Replace the Finisher Controller PCB.
Keep in mind, not every error is entirely the same. What remedies the situation one time might not remedy it the next occasion. While the content in this blog hails from the service manual and most often should get your device operating, from time to time other causes may be in play.
If you are reading this blog post and have information about this error message and would like to make a contribution please make sure to leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the trouble then I will answer back.
