Canon imageRUNNER 1750 E537 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E537 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E537 8002 Error Code
E537 8002
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to be detected by the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 0.78sec.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Keep in mind, not every error is entirely identical. What corrects the situation one occasion may possibly not take care of it the next occasion. While the content in this posting obtain from the service manual and in most cases ought to get your piece of equipment functioning, occasionally other elements could possibly be in play.
If you are reading this blog post and have exposure to this malfunction and want to share make sure you leave a comment below. Or, if you have read this article and have additional questions then ask. If I have experience with the problem then I will answer back.
