Canon imageRUNNER 1750 E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E531 8002 Error Code
E531 8002
Description :
Staple Motor (M9) error
Causes :
After execution of staple operation, the motor was operated in the positive direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46 seconds. Then, the motor was rotated in the negative direction, but the Staple Unit could not be detected by the Staple HP Sensor (S11) within 0.46sec.
Solutions :
1. Check the connector connection of the Staple Unit.
2. Disconnect the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.
Keep in mind, not every error is entirely alike. What treats the problem one occasion will possibly not eliminate it the next time. While the information in this written piece hails from the service manual and most often should get your product operational, in some cases other things may be in play.
If you are reading this blog post and have exposure to this error and want to share make sure you leave a comment down below. Or, if you have read this article and have more questions then ask. If I have experience with the problem then I will answer.