Canon imageRUNNER 1750 E530 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1750 E530 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1750 E530 8001 Error Code
E530 8001
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to move from the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Keep in mind, not every error is entirely alike. What fixes the issue one occasion will possibly not remedy it the next time. While the content in this article comes from the service manual and usually ought to get your device functioning, now and again additional factors might be in play.
If you are reading this blog post and have expertise in this error and desire to make a contribution you should leave a comment down the page. Or, if you have read this article and have additional questions then ask. If I have information about the trouble then I will answer.
