Canon imageRUNNER 1750 E003 0000 Error Code

 

Canon imageRUNNER 1750 E003 0000 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1750 E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1750 E003 0000 Error Code

Service Manual Instructions for the Canon imageRUNNER 1750 E003 0000 Error Code

E003 0000
Description :
Detection of fixing low temperature during printing

Causes :
The Main Thermistor detected a temperature lower than 80 deg C for 200 msec or longer on end, or the Sub Thermistor detected a temperature lower than 60 deg C for 200 msec or longer on end.

Solutions :
1. Go through the following to clear the error: CLEAR > ENGIN > ERRCLR in Service Mode; then, turn OFF and then ON the power.
2. Check the connector connection. (J206 on the DC Controller PCB, J101 on the Power Supply PCB)
3. Replace the Fixing Assembly.
4. Replace the DC Controller PCB (PCB1).


Canon FM1-B701-000 Fuser (Fixing) Unit – 110 / 120 Volt (Genuine) – $279.95

from: Precision Roller

Canon imageRUNNER 1730 E000, E001, E002, E003, Error Code Reset


Canon imageRUNNER 1730 Fuser Removal and Replacement

Just remember, not every error is simply alike. What corrects the complication one occasion may possibly not fix it the next occasion. While the advice in this document comes from the service manual and most often should get your product ready to go, sometimes additional circumstances may be in play.

If you are looking over this write-up and have expertise in this fault and would like to make a contribution please make sure to leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the difficulty then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart