Canon imageRUNNER 1740iF E822 0005 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E822 0005 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E822 0005 Error Code
E822 0005
Description :
Error in rotation of the Delivery Cooling Fan (Rear) (FM1)
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Rear) (FM1) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Rear) (FM1).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is precisely identical. What treats the malfunction one occasion will possibly not get rid of it the next time. While the data in this writing hails from the service manual and most likely ought to get your unit ready to go, occasionally other factors might be in play.
If you are looking over this write-up and have experience with this error message and would like to contribute make sure you leave a comment beneath. Or, if you have read this article and have additional questions then ask. If I have knowledge about the situation then I will answer.
