Canon imageRUNNER 1740iF E822 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E822 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E822 0000 Error Code
E822 0000
Description :
Delivery Cooling Fan (Front) (FM3) error
Causes :
A lock signal was detected for 5 seconds while the Delivery Cooling Fan (Front) (FM3) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J210) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Delivery Cooling Fan (Front) (FM3).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is precisely alike. What corrects the issue one time might not exactly take care of it the next occasion. While the content in this blog post originates from the service manual and oftentimes ought to get your equipment up and running, in some cases additional factors might be in play.
If you are looking over this short article and have knowledge about this error and want to share please leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have exposure to the problem then I will answer.
