Canon imageRUNNER 1740iF E820 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E820 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E820 0001 Error Code
E820 0001
Description :
Error in rotation of the Developing Cooling Fan (Front) (FM7)
Causes :
A lock signal could not be detected for 5 seconds while the Developing Cooling Fan (Front) (FM7) was being driven.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J209) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Developing Cooling Fan (Front) (FM7).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is exactly identical. What remedies the complication one time may not take care of it the next time. While the advice in this written piece obtain from the service manual and typically should get your piece of equipment up and running, sometimes other things may be in play.
If you are looking over this short article and have information about this malfunction and would like to contribute make sure you leave a comment below. Or, if you have read this article and have additional questions then ask. If I have exposure to the trouble then I will respond.
