Canon imageRUNNER 1740iF E805 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E805 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E805 0002 Error Code
E805 0002
Description :
Heat Exhaust Fan (Front) (FM5) error
Causes :
A lock signal was detected for 5 seconds while the Heat Exhaust Fan (Front) (FM5) was being stopped.
The same status was detected again after executing an error retry.
Solutions :
1. Disconnect and then connect the connector (J212) on the DC Controller PCB (PCB1) to check the connection.
2. Replace the Heat Exhaust Fan (Front) (FM5).
3. Replace the DC Controller PCB (PCB1).
Just remember, not every error is exactly alike. What fixes the trouble one time might not take care of it the next occasion. While the tips in this page comes from the service manual and most often should get your equipment working, occasionally other reasons could possibly be in play.
If you are looking over this short article and have exposure to this error message and would like to make a contribution be sure to leave a comment underneath. Or, if you have read this article and have more questions then ask. If I have knowledge about the problem then I will respond.
