Canon imageRUNNER 1740iF E575 8004 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E575 8004 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E575 8004 Error Code
E575 8004
Description :
Gripper Motor (M7) clock error
Causes :
When the Gripper Motor (M7) was operated, the Gripper Encoder Sensor (S8) detected rotation of 400 clocks or more.
Solutions :
1. Check the connector connection of the Gripper Encoder Sensor (S8) or the Gripper Motor (M7).
2. Check for open circuit of the Harness of the Gripper Encoder Sensor (S8) or the Gripper Motor (M7).
3. Replace the Gripper Encoder Sensor (S8).
4. Replace the Gripper Motor (M7).
5. Replace the Finisher Controller PCB.
Just remember, not every error is entirely identical. What corrects the condition one time will possibly not take care of it the next time. While the data in this blog post is obtained from the service manual and most likely should get your piece of equipment working, sometimes additional factors could possibly be in play.
If you are looking over this post and have knowledge of this problem and desire to make a contribution please leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have information about the problem then I will respond.
