Canon imageRUNNER 1740iF E540 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E540 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E540 8001 Error Code
E540 8001
Description :
Stack Tray Shift Motor (M8) error
Causes :
The Stack Tray Shift Motor (M8) was driven for 4 seconds, but the Stack Tray shifting operation could not be completed.
Solutions :
1. Check the connector connection of the Stack Tray Paper Height Sensor (S9) or the Stack Tray Shift Motor (M8).
2. Check for open circuit of the Harness of the Stack Tray Paper Height Sensor (S9) or the Stack Tray Shift Motor (M8).
3. Replace the Stack Tray Paper Height Sensor (S9).
4. Replace the Stack Tray Shift Motor (M8).
5. Replace the Finisher Controller PCB.
Just remember, not every error is entirely alike. What fixes the difficulty one occasion might not exactly fix it the next occasion. While the help and advice in this page is obtained from the service manual and most likely ought to get your equipment operational, occasionally additional variables might be in play.
If you are looking over this post and have knowledge of this fault and would like to share please leave a comment below. Or, if you have read this article and have additional questions then ask. If I have exposure to the problem then I will reply.
