Canon imageRUNNER 1740iF E537 8001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E537 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E537 8001 Error Code
E537 8001
Description :
Rear Alignment Motor (M5) error
Causes :
At initialization of the Rear Alignment Plate, the Rear Alignment Plate failed to move from the Rear Alignment Plate HP Sensor (S5) although the Rear Alignment Motor (M5) was driven for 10 mm.
Solutions :
1. Check the connector connection of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
2. Check for open circuit of the Harness of the Rear Alignment Plate HP Sensor (S5) or the Rear Alignment Motor (M5).
3. Replace the Rear Alignment Plate HP Sensor (S5).
4. Replace the Rear Alignment Motor (M5).
5. Replace the Finisher Controller PCB.
Just remember, not every error is completely the same. What treats the complication one time may not eliminate it the next occasion. While the material in this page hails from the service manual and typically should get your device functioning, on occasion additional circumstances may be in play.
If you are looking over this post and have knowledge of this error and wish to contribute you should leave a comment below. Or, if you have read this article and have additional questions then ask. If I have knowledge about the problem then I will answer.
