Canon imageRUNNER 1740iF E531 8001 Error Code

 

Canon imageRUNNER 1740iF E531 8001 Error Code Instructions

Below you will find the service manual information for the Canon imageRUNNER 1740iF E531 8001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it. 

Canon imageRUNNER 1740iF E531 8001 Error Code

Service Manual Instructions for the Canon imageRUNNER 1740iF E531 8001 Error Code

E531 8001
Description :
Staple Motor (M9) error

Causes :
The Stapler failed to move from the Staple HP Sensor (S11) within the staple execution time (0.45sec).

Solutions :
1. Check the connector connection of the Staple Unit.
2. Check for open circuit of the Harness of the Staple Unit.
3. Replace the Staple Unit.
4. Replace the Finisher Controller PCB.


Just remember, not every error is completely the same. What fixes the condition one time might not exactly remedy it the next occasion. While the advice in this page comes from the service manual and most often ought to get your device up and running, sometimes other variables might be in play.

If you are looking over this post and have knowledge of this error and desire to share make sure you leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have experience with the issue then I will reply.

We will be happy to hear your thoughts

Leave a reply

Shopping cart