Canon imageRUNNER 1740iF E530 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E530 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E530 8002 Error Code
E530 8002
Description :
Front Alignment Motor (M4) error
Causes :
At initialization of the Front Alignment Plate, the Front Alignment Plate failed to be detected by the Front Alignment Plate HP Sensor (S4) although the Front Alignment Motor (M4) was driven for 0.78 seconds.
Solutions :
1. Check the connector connection of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
2. Check for open circuit of the Harness of the Front Alignment Plate HP Sensor (S4) or the Front Alignment Motor (M4).
3. Replace the Front Alignment Plate HP Sensor (S4).
4. Replace the Front Alignment Motor (M4).
5. Replace the Finisher Controller PCB.
Just remember, not every error is completely identical. What treats the malfunction one time might not remedy it the next time. While the tips in this short article originates from the service manual and most often should get your machine working, in some cases other reasons might be in play.
If you are looking over this post and have knowledge about this problem and wish to contribute you should leave a comment down below. Or, if you have read this article and have more questions then ask. If I have exposure to the trouble then I will respond.
