Canon imageRUNNER 1740iF E261 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 1740iF E261 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.Â
Service Manual Instructions for the Canon imageRUNNER 1740iF E261 0000 Error Code
E261 0000
Description :
Zero cross signal error
Causes :
When the relay is ON, the zero cross signal failed to be detected for 500 msec or longer.
When the same status was detected again after executing an error retry.
Solutions :
1. Check the connector connection. (All connectors on the DC Controller PCB)
2. Replace the DC Controller PCB (PCB1).
Just remember, not every error is absolutely identical. What fixes the trouble one time might not resolve it the next time. While the tips in this document is taken from the service manual and in most cases ought to get your product up and running, at times additional circumstances could possibly be in play.
If you are looking over this post and have expertise in this fault and wish to share please be sure to leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have exposure to the trouble then I will answer back.
